diff options
Diffstat (limited to 'Documentation/devicetree/bindings/gpio/gpio-max732x.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/gpio/gpio-max732x.txt | 59 |
1 files changed, 59 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-max732x.txt b/Documentation/devicetree/bindings/gpio/gpio-max732x.txt new file mode 100644 index 000000000..5fdc843b4 --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/gpio-max732x.txt @@ -0,0 +1,59 @@ +* MAX732x-compatible I/O expanders + +Required properties: + - compatible: Should be one of the following: + - "maxim,max7319": For the Maxim MAX7319 + - "maxim,max7320": For the Maxim MAX7320 + - "maxim,max7321": For the Maxim MAX7321 + - "maxim,max7322": For the Maxim MAX7322 + - "maxim,max7323": For the Maxim MAX7323 + - "maxim,max7324": For the Maxim MAX7324 + - "maxim,max7325": For the Maxim MAX7325 + - "maxim,max7326": For the Maxim MAX7326 + - "maxim,max7327": For the Maxim MAX7327 + - reg: I2C slave address for this device. + - gpio-controller: Marks the device node as a GPIO controller. + - #gpio-cells: Should be 2. + - first cell is the GPIO number + - second cell specifies GPIO flags, as defined in <dt-bindings/gpio/gpio.h>. + Only the GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW flags are supported. + +Optional properties: + + The I/O expander can detect input state changes, and thus optionally act as + an interrupt controller. When the expander interrupt line is connected all the + following properties must be set. For more information please see the + interrupt controller device tree bindings documentation available at + Documentation/devicetree/bindings/interrupt-controller/interrupts.txt. + + - interrupt-controller: Identifies the node as an interrupt controller. + - #interrupt-cells: Number of cells to encode an interrupt source, shall be 2. + - first cell is the pin number + - second cell is used to specify flags + - interrupt-parent: phandle of the parent interrupt controller. + - interrupts: Interrupt specifier for the controllers interrupt. + +Please refer to gpio.txt in this directory for details of the common GPIO +bindings used by client devices. + +Example 1. MAX7325 with interrupt support enabled (CONFIG_GPIO_MAX732X_IRQ=y): + + expander: max7325@6d { + compatible = "maxim,max7325"; + reg = <0x6d>; + gpio-controller; + #gpio-cells = <2>; + interrupt-controller; + #interrupt-cells = <2>; + interrupt-parent = <&gpio4>; + interrupts = <29 IRQ_TYPE_EDGE_FALLING>; + }; + +Example 2. MAX7325 with interrupt support disabled (CONFIG_GPIO_MAX732X_IRQ=n): + + expander: max7325@6d { + compatible = "maxim,max7325"; + reg = <0x6d>; + gpio-controller; + #gpio-cells = <2>; + }; |