1 files changed, 55 insertions, 0 deletions
diff --git a/Documentation/sound/oss/ESS1868 b/Documentation/sound/oss/ESS1868
new file mode 100644
index 000000000..55e922f21
--- /dev/null
+++ b/Documentation/sound/oss/ESS1868
@@ -0,0 +1,55 @@
+Documentation for the ESS1868F AudioDrive PnP sound card
+
+The ESS1868 sound card is a PnP ESS1688-compatible 16-bit sound card.
+
+It should be automatically detected by the Linux Kernel isapnp support when you
+load the sb.o module. Otherwise you should take care of:
+
+  *  The ESS1868 does not allow use of a 16-bit DMA, thus DMA 0, 1, 2, and 3
+     may only be used.
+
+  *  isapnptools version 1.14 does work with ESS1868.  Earlier versions might
+     not.
+
+  *  Sound support MUST be compiled as MODULES, not statically linked
+     into the kernel.
+
+
+NOTE: this is only needed when not using the kernel isapnp support!
+
+For configuring the sound card's I/O addresses, IRQ and DMA, here is a
+sample copy of the isapnp.conf directives regarding the ESS1868:
+
+(CONFIGURE ESS1868/-1 (LD 1
+(IO 0 (BASE 0x0220))
+(IO 1 (BASE 0x0388))
+(IO 2 (BASE 0x0330))
+(DMA 0 (CHANNEL 1))
+(INT 0 (IRQ 5 (MODE +E)))
+(ACT Y)
+))
+
+(for a full working isapnp.conf file, remember the
+(ISOLATE)
+(IDENTIFY *)
+at the beginning and the
+(WAITFORKEY)
+at the end.)
+
+In this setup, the main card I/O is 0x0220, FM synthesizer is 0x0388, and
+the MPU-401 MIDI port is located at 0x0330.  IRQ is IRQ 5, DMA is channel 1.
+
+After configuring the sound card via isapnp, to use the card you must load
+the sound modules with the proper I/O information.  Here is my setup:
+
+# ESS1868F AudioDrive initialization
+
+/sbin/modprobe sound
+/sbin/insmod uart401
+/sbin/insmod sb io=0x220 irq=5 dma=1 dma16=-1
+/sbin/insmod mpu401 io=0x330
+/sbin/insmod opl3 io=0x388
+/sbin/insmod v_midi
+
+opl3 is the FM synthesizer
+/sbin/insmod opl3 io=0x388