diff options
Diffstat (limited to 'Documentation/x86')
| -rw-r--r-- | Documentation/x86/boot.txt | 3 | ||||
| -rw-r--r-- | Documentation/x86/entry_64.txt | 12 | ||||
| -rw-r--r-- | Documentation/x86/kernel-stacks (renamed from Documentation/x86/x86_64/kernel-stacks) | 54 | ||||
| -rw-r--r-- | Documentation/x86/mtrr.txt | 18 | ||||
| -rw-r--r-- | Documentation/x86/pat.txt | 48 | ||||
| -rw-r--r-- | Documentation/x86/x86_64/boot-options.txt | 3 |
6 files changed, 115 insertions, 23 deletions
diff --git a/Documentation/x86/boot.txt b/Documentation/x86/boot.txt index 88b85899d..9da6f3512 100644 --- a/Documentation/x86/boot.txt +++ b/Documentation/x86/boot.txt @@ -406,7 +406,7 @@ Protocol: 2.00+ - If 0, the protected-mode code is loaded at 0x10000. - If 1, the protected-mode code is loaded at 0x100000. - Bit 1 (kernel internal): ALSR_FLAG + Bit 1 (kernel internal): KASLR_FLAG - Used internally by the compressed kernel to communicate KASLR status to kernel proper. If 1, KASLR enabled. @@ -1124,7 +1124,6 @@ The boot loader *must* fill out the following fields in bp, o hdr.code32_start o hdr.cmd_line_ptr - o hdr.cmdline_size o hdr.ramdisk_image (if applicable) o hdr.ramdisk_size (if applicable) diff --git a/Documentation/x86/entry_64.txt b/Documentation/x86/entry_64.txt index 9132b8617..c1df8eba9 100644 --- a/Documentation/x86/entry_64.txt +++ b/Documentation/x86/entry_64.txt @@ -1,14 +1,14 @@ This file documents some of the kernel entries in -arch/x86/kernel/entry_64.S. A lot of this explanation is adapted from +arch/x86/entry/entry_64.S. A lot of this explanation is adapted from an email from Ingo Molnar: http://lkml.kernel.org/r/<20110529191055.GC9835%40elte.hu> The x86 architecture has quite a few different ways to jump into kernel code. Most of these entry points are registered in -arch/x86/kernel/traps.c and implemented in arch/x86/kernel/entry_64.S -for 64-bit, arch/x86/kernel/entry_32.S for 32-bit and finally -arch/x86/ia32/ia32entry.S which implements the 32-bit compatibility +arch/x86/kernel/traps.c and implemented in arch/x86/entry/entry_64.S +for 64-bit, arch/x86/entry/entry_32.S for 32-bit and finally +arch/x86/entry/entry_64_compat.S which implements the 32-bit compatibility syscall entry points and thus provides for 32-bit processes the ability to execute syscalls when running on 64-bit kernels. @@ -18,10 +18,10 @@ Some of these entries are: - system_call: syscall instruction from 64-bit code. - - ia32_syscall: int 0x80 from 32-bit or 64-bit code; compat syscall + - entry_INT80_compat: int 0x80 from 32-bit or 64-bit code; compat syscall either way. - - ia32_syscall, ia32_sysenter: syscall and sysenter from 32-bit + - entry_INT80_compat, ia32_sysenter: syscall and sysenter from 32-bit code - interrupt: An array of entries. Every IDT vector that doesn't diff --git a/Documentation/x86/x86_64/kernel-stacks b/Documentation/x86/kernel-stacks index e3c8a49d1..0f3a6c201 100644 --- a/Documentation/x86/x86_64/kernel-stacks +++ b/Documentation/x86/kernel-stacks @@ -1,3 +1,6 @@ +Kernel stacks on x86-64 bit +--------------------------- + Most of the text from Keith Owens, hacked by AK x86_64 page size (PAGE_SIZE) is 4K. @@ -56,13 +59,6 @@ If that assumption is ever broken then the stacks will become corrupt. The currently assigned IST stacks are :- -* STACKFAULT_STACK. EXCEPTION_STKSZ (PAGE_SIZE). - - Used for interrupt 12 - Stack Fault Exception (#SS). - - This allows the CPU to recover from invalid stack segments. Rarely - happens. - * DOUBLEFAULT_STACK. EXCEPTION_STKSZ (PAGE_SIZE). Used for interrupt 8 - Double Fault Exception (#DF). @@ -99,3 +95,47 @@ The currently assigned IST stacks are :- assumptions about the previous state of the kernel stack. For more details see the Intel IA32 or AMD AMD64 architecture manuals. + + +Printing backtraces on x86 +-------------------------- + +The question about the '?' preceding function names in an x86 stacktrace +keeps popping up, here's an indepth explanation. It helps if the reader +stares at print_context_stack() and the whole machinery in and around +arch/x86/kernel/dumpstack.c. + +Adapted from Ingo's mail, Message-ID: <20150521101614.GA10889@gmail.com>: + +We always scan the full kernel stack for return addresses stored on +the kernel stack(s) [*], from stack top to stack bottom, and print out +anything that 'looks like' a kernel text address. + +If it fits into the frame pointer chain, we print it without a question +mark, knowing that it's part of the real backtrace. + +If the address does not fit into our expected frame pointer chain we +still print it, but we print a '?'. It can mean two things: + + - either the address is not part of the call chain: it's just stale + values on the kernel stack, from earlier function calls. This is + the common case. + + - or it is part of the call chain, but the frame pointer was not set + up properly within the function, so we don't recognize it. + +This way we will always print out the real call chain (plus a few more +entries), regardless of whether the frame pointer was set up correctly +or not - but in most cases we'll get the call chain right as well. The +entries printed are strictly in stack order, so you can deduce more +information from that as well. + +The most important property of this method is that we _never_ lose +information: we always strive to print _all_ addresses on the stack(s) +that look like kernel text addresses, so if debug information is wrong, +we still print out the real call chain as well - just with more question +marks than ideal. + +[*] For things like IRQ and IST stacks, we also scan those stacks, in + the right order, and try to cross from one stack into another + reconstructing the call chain. This works most of the time. diff --git a/Documentation/x86/mtrr.txt b/Documentation/x86/mtrr.txt index cc071dc33..860bc3adc 100644 --- a/Documentation/x86/mtrr.txt +++ b/Documentation/x86/mtrr.txt @@ -1,7 +1,19 @@ MTRR (Memory Type Range Register) control -3 Jun 1999 -Richard Gooch -<rgooch@atnf.csiro.au> + +Richard Gooch <rgooch@atnf.csiro.au> - 3 Jun 1999 +Luis R. Rodriguez <mcgrof@do-not-panic.com> - April 9, 2015 + +=============================================================================== +Phasing out MTRR use + +MTRR use is replaced on modern x86 hardware with PAT. Over time the only type +of effective MTRR that is expected to be supported will be for write-combining. +As MTRR use is phased out device drivers should use arch_phys_wc_add() to make +MTRR effective on non-PAT systems while a no-op on PAT enabled systems. + +For details refer to Documentation/x86/pat.txt. + +=============================================================================== On Intel P6 family processors (Pentium Pro, Pentium II and later) the Memory Type Range Registers (MTRRs) may be used to control diff --git a/Documentation/x86/pat.txt b/Documentation/x86/pat.txt index cf08c9fff..54944c71b 100644 --- a/Documentation/x86/pat.txt +++ b/Documentation/x86/pat.txt @@ -12,7 +12,7 @@ virtual addresses. PAT allows for different types of memory attributes. The most commonly used ones that will be supported at this time are Write-back, Uncached, -Write-combined and Uncached Minus. +Write-combined, Write-through and Uncached Minus. PAT APIs @@ -34,16 +34,23 @@ ioremap | -- | UC- | UC- | | | | | ioremap_cache | -- | WB | WB | | | | | +ioremap_uc | -- | UC | UC | + | | | | ioremap_nocache | -- | UC- | UC- | | | | | ioremap_wc | -- | -- | WC | | | | | +ioremap_wt | -- | -- | WT | + | | | | set_memory_uc | UC- | -- | -- | set_memory_wb | | | | | | | | set_memory_wc | WC | -- | -- | set_memory_wb | | | | | | | | +set_memory_wt | WT | -- | -- | + set_memory_wb | | | | + | | | | pci sysfs resource | -- | -- | UC- | | | | | pci sysfs resource_wc | -- | -- | WC | @@ -102,7 +109,38 @@ wants to export a RAM region, it has to do set_memory_uc() or set_memory_wc() as step 0 above and also track the usage of those pages and use set_memory_wb() before the page is freed to free pool. - +MTRR effects on PAT / non-PAT systems +------------------------------------- + +The following table provides the effects of using write-combining MTRRs when +using ioremap*() calls on x86 for both non-PAT and PAT systems. Ideally +mtrr_add() usage will be phased out in favor of arch_phys_wc_add() which will +be a no-op on PAT enabled systems. The region over which a arch_phys_wc_add() +is made, should already have been ioremapped with WC attributes or PAT entries, +this can be done by using ioremap_wc() / set_memory_wc(). Devices which +combine areas of IO memory desired to remain uncacheable with areas where +write-combining is desirable should consider use of ioremap_uc() followed by +set_memory_wc() to white-list effective write-combined areas. Such use is +nevertheless discouraged as the effective memory type is considered +implementation defined, yet this strategy can be used as last resort on devices +with size-constrained regions where otherwise MTRR write-combining would +otherwise not be effective. + +---------------------------------------------------------------------- +MTRR Non-PAT PAT Linux ioremap value Effective memory type +---------------------------------------------------------------------- + Non-PAT | PAT + PAT + |PCD + ||PWT + ||| +WC 000 WB _PAGE_CACHE_MODE_WB WC | WC +WC 001 WC _PAGE_CACHE_MODE_WC WC* | WC +WC 010 UC- _PAGE_CACHE_MODE_UC_MINUS WC* | UC +WC 011 UC _PAGE_CACHE_MODE_UC UC | UC +---------------------------------------------------------------------- + +(*) denotes implementation defined and is discouraged Notes: @@ -115,8 +153,8 @@ can be more restrictive, in case of any existing aliasing for that address. For example: If there is an existing uncached mapping, a new ioremap_wc can return uncached mapping in place of write-combine requested. -set_memory_[uc|wc] and set_memory_wb should be used in pairs, where driver will -first make a region uc or wc and switch it back to wb after use. +set_memory_[uc|wc|wt] and set_memory_wb should be used in pairs, where driver +will first make a region uc, wc or wt and switch it back to wb after use. Over time writes to /proc/mtrr will be deprecated in favor of using PAT based interfaces. Users writing to /proc/mtrr are suggested to use above interfaces. @@ -124,7 +162,7 @@ interfaces. Users writing to /proc/mtrr are suggested to use above interfaces. Drivers should use ioremap_[uc|wc] to access PCI BARs with [uc|wc] access types. -Drivers should use set_memory_[uc|wc] to set access type for RAM ranges. +Drivers should use set_memory_[uc|wc|wt] to set access type for RAM ranges. PAT debugging diff --git a/Documentation/x86/x86_64/boot-options.txt b/Documentation/x86/x86_64/boot-options.txt index 522347929..68ed3114c 100644 --- a/Documentation/x86/x86_64/boot-options.txt +++ b/Documentation/x86/x86_64/boot-options.txt @@ -31,6 +31,9 @@ Machine check (e.g. BIOS or hardware monitoring applications), conflicting with OS's error handling, and you cannot deactivate the agent, then this option will be a help. + mce=no_lmce + Do not opt-in to Local MCE delivery. Use legacy method + to broadcast MCEs. mce=bootlog Enable logging of machine checks left over from booting. Disabled by default on AMD because some BIOS leave bogus ones. |