diff options
Diffstat (limited to 'arch/powerpc/boot/dts/p1025twr.dtsi')
| -rw-r--r-- | arch/powerpc/boot/dts/p1025twr.dtsi | 280 |
1 files changed, 280 insertions, 0 deletions
diff --git a/arch/powerpc/boot/dts/p1025twr.dtsi b/arch/powerpc/boot/dts/p1025twr.dtsi new file mode 100644 index 000000000..8453501c2 --- /dev/null +++ b/arch/powerpc/boot/dts/p1025twr.dtsi @@ -0,0 +1,280 @@ +/* + * P1025 TWR Device Tree Source stub (no addresses or top-level ranges) + * + * Copyright 2013 Freescale Semiconductor Inc. + * + * Redistribution and use in source and binary forms, with or without + * modification, are permitted provided that the following conditions are met: + * * Redistributions of source code must retain the above copyright + * notice, this list of conditions and the following disclaimer. + * * Redistributions in binary form must reproduce the above copyright + * notice, this list of conditions and the following disclaimer in the + * documentation and/or other materials provided with the distribution. + * * Neither the name of Freescale Semiconductor nor the + * names of its contributors may be used to endorse or promote products + * derived from this software without specific prior written permission. + * + * + * ALTERNATIVELY, this software may be distributed under the terms of the + * GNU General Public License ("GPL") as published by the Free Software + * Foundation, either version 2 of that License or (at your option) any + * later version. + * + * THIS SOFTWARE IS PROVIDED BY Freescale Semiconductor ``AS IS'' AND ANY + * EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED + * WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE + * DISCLAIMED. IN NO EVENT SHALL Freescale Semiconductor BE LIABLE FOR ANY + * DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES + * (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; + * LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND + * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT + * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS + * SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. + */ + +/{ + aliases { + ethernet3 = &enet3; + ethernet4 = &enet4; + }; +}; + +&lbc { + nor@0,0 { + #address-cells = <1>; + #size-cells = <1>; + compatible = "cfi-flash"; + reg = <0x0 0x0 0x4000000>; + bank-width = <2>; + device-width = <1>; + + partition@0 { + /* This location must not be altered */ + /* 256KB for Vitesse 7385 Switch firmware */ + reg = <0x0 0x00040000>; + label = "NOR Vitesse-7385 Firmware"; + read-only; + }; + + partition@40000 { + /* 256KB for DTB Image */ + reg = <0x00040000 0x00040000>; + label = "NOR DTB Image"; + }; + + partition@80000 { + /* 5.5 MB for Linux Kernel Image */ + reg = <0x00080000 0x00580000>; + label = "NOR Linux Kernel Image"; + }; + + partition@400000 { + /* 56.75MB for Root file System */ + reg = <0x00600000 0x038c0000>; + label = "NOR Root File System"; + }; + + partition@ec0000 { + /* This location must not be altered */ + /* 256KB for QE ucode firmware*/ + reg = <0x03ec0000 0x00040000>; + label = "NOR QE microcode firmware"; + read-only; + }; + + partition@f00000 { + /* This location must not be altered */ + /* 512KB for u-boot Bootloader Image */ + /* 512KB for u-boot Environment Variables */ + reg = <0x03f00000 0x00100000>; + label = "NOR U-Boot Image"; + read-only; + }; + }; + + /* CS2 for Display */ + display@2,0 { + compatible = "solomon,ssd1289fb"; + reg = <0x2 0x0000 0x0004>; + }; + +}; + +&soc { + usb@22000 { + phy_type = "ulpi"; + }; + + mdio@24000 { + phy0: ethernet-phy@2 { + interrupt-parent = <&mpic>; + interrupts = <1 1 0 0>; + reg = <0x2>; + }; + + phy1: ethernet-phy@1 { + interrupt-parent = <&mpic>; + interrupts = <2 1 0 0>; + reg = <0x1>; + }; + + tbi0: tbi-phy@11 { + reg = <0x11>; + device_type = "tbi-phy"; + }; + }; + + mdio@25000 { + tbi1: tbi-phy@11 { + reg = <0x11>; + device_type = "tbi-phy"; + }; + }; + + mdio@26000 { + tbi2: tbi-phy@11 { + reg = <0x11>; + device_type = "tbi-phy"; + }; + }; + + enet0: ethernet@b0000 { + phy-handle = <&phy0>; + phy-connection-type = "rgmii-id"; + + }; + + enet1: ethernet@b1000 { + status = "disabled"; + }; + + enet2: ethernet@b2000 { + phy-handle = <&phy1>; + phy-connection-type = "rgmii-id"; + }; + + par_io@e0100 { + #address-cells = <1>; + #size-cells = <1>; + reg = <0xe0100 0x60>; + ranges = <0x0 0xe0100 0x60>; + device_type = "par_io"; + num-ports = <3>; + pio1: ucc_pin@01 { + pio-map = < + /* port pin dir open_drain assignment has_irq */ + 0x1 0x13 0x1 0x0 0x1 0x0 /* QE_MUX_MDC */ + 0x1 0x14 0x3 0x0 0x1 0x0 /* QE_MUX_MDIO */ + 0x0 0x17 0x2 0x0 0x2 0x0 /* CLK12 */ + 0x0 0x18 0x2 0x0 0x1 0x0 /* CLK9 */ + 0x0 0x7 0x1 0x0 0x2 0x0 /* ENET1_TXD0_SER1_TXD0 */ + 0x0 0x9 0x1 0x0 0x2 0x0 /* ENET1_TXD1_SER1_TXD1 */ + 0x0 0xb 0x1 0x0 0x2 0x0 /* ENET1_TXD2_SER1_TXD2 */ + 0x0 0xc 0x1 0x0 0x2 0x0 /* ENET1_TXD3_SER1_TXD3 */ + 0x0 0x6 0x2 0x0 0x2 0x0 /* ENET1_RXD0_SER1_RXD0 */ + 0x0 0xa 0x2 0x0 0x2 0x0 /* ENET1_RXD1_SER1_RXD1 */ + 0x0 0xe 0x2 0x0 0x2 0x0 /* ENET1_RXD2_SER1_RXD2 */ + 0x0 0xf 0x2 0x0 0x2 0x0 /* ENET1_RXD3_SER1_RXD3 */ + 0x0 0x5 0x1 0x0 0x2 0x0 /* ENET1_TX_EN_SER1_RTS_B */ + 0x0 0xd 0x1 0x0 0x2 0x0 /* ENET1_TX_ER */ + 0x0 0x4 0x2 0x0 0x2 0x0 /* ENET1_RX_DV_SER1_CTS_B */ + 0x0 0x8 0x2 0x0 0x2 0x0 /* ENET1_RX_ER_SER1_CD_B */ + 0x0 0x11 0x2 0x0 0x2 0x0 /* ENET1_CRS */ + 0x0 0x10 0x2 0x0 0x2 0x0>; /* ENET1_COL */ + }; + + pio2: ucc_pin@02 { + pio-map = < + /* port pin dir open_drain assignment has_irq */ + 0x1 0x13 0x1 0x0 0x1 0x0 /* QE_MUX_MDC */ + 0x1 0x14 0x3 0x0 0x1 0x0 /* QE_MUX_MDIO */ + 0x1 0xb 0x2 0x0 0x1 0x0 /* CLK13 */ + 0x1 0x7 0x1 0x0 0x2 0x0 /* ENET5_TXD0_SER5_TXD0 */ + 0x1 0xa 0x1 0x0 0x2 0x0 /* ENET5_TXD1_SER5_TXD1 */ + 0x1 0x6 0x2 0x0 0x2 0x0 /* ENET5_RXD0_SER5_RXD0 */ + 0x1 0x9 0x2 0x0 0x2 0x0 /* ENET5_RXD1_SER5_RXD1 */ + 0x1 0x5 0x1 0x0 0x2 0x0 /* ENET5_TX_EN_SER5_RTS_B */ + 0x1 0x4 0x2 0x0 0x2 0x0 /* ENET5_RX_DV_SER5_CTS_B */ + 0x1 0x8 0x2 0x0 0x2 0x0>; /* ENET5_RX_ER_SER5_CD_B */ + }; + + pio3: ucc_pin@03 { + pio-map = < + /* port pin dir open_drain assignment has_irq */ + 0x0 0x16 0x2 0x0 0x2 0x0 /* SER7_CD_B*/ + 0x0 0x12 0x2 0x0 0x2 0x0 /* SER7_CTS_B*/ + 0x0 0x13 0x1 0x0 0x2 0x0 /* SER7_RTS_B*/ + 0x0 0x14 0x2 0x0 0x2 0x0 /* SER7_RXD0*/ + 0x0 0x15 0x1 0x0 0x2 0x0>; /* SER7_TXD0*/ + }; + + pio4: ucc_pin@04 { + pio-map = < + /* port pin dir open_drain assignment has_irq */ + 0x1 0x0 0x2 0x0 0x2 0x0 /* SER3_CD_B*/ + 0x0 0x1c 0x2 0x0 0x2 0x0 /* SER3_CTS_B*/ + 0x0 0x1d 0x1 0x0 0x2 0x0 /* SER3_RTS_B*/ + 0x0 0x1e 0x2 0x0 0x2 0x0 /* SER3_RXD0*/ + 0x0 0x1f 0x1 0x0 0x2 0x0>; /* SER3_TXD0*/ + }; + }; +}; + +&qe { + enet3: ucc@2000 { + device_type = "network"; + compatible = "ucc_geth"; + rx-clock-name = "clk12"; + tx-clock-name = "clk9"; + pio-handle = <&pio1>; + phy-handle = <&qe_phy0>; + phy-connection-type = "mii"; + }; + + mdio@2120 { + qe_phy0: ethernet-phy@18 { + interrupt-parent = <&mpic>; + interrupts = <4 1 0 0>; + reg = <0x18>; + device_type = "ethernet-phy"; + }; + qe_phy1: ethernet-phy@19 { + interrupt-parent = <&mpic>; + interrupts = <5 1 0 0>; + reg = <0x19>; + device_type = "ethernet-phy"; + }; + tbi-phy@11 { + reg = <0x11>; + device_type = "tbi-phy"; + }; + }; + + enet4: ucc@2400 { + device_type = "network"; + compatible = "ucc_geth"; + rx-clock-name = "none"; + tx-clock-name = "clk13"; + pio-handle = <&pio2>; + phy-handle = <&qe_phy1>; + phy-connection-type = "rmii"; + }; + + serial2: ucc@2600 { + device_type = "serial"; + compatible = "ucc_uart"; + port-number = <0>; + rx-clock-name = "brg6"; + tx-clock-name = "brg6"; + pio-handle = <&pio3>; + }; + + serial3: ucc@2200 { + device_type = "serial"; + compatible = "ucc_uart"; + port-number = <1>; + rx-clock-name = "brg2"; + tx-clock-name = "brg2"; + pio-handle = <&pio4>; + }; +}; |