diff options
Diffstat (limited to 'drivers/block/cciss_cmd.h')
| -rw-r--r-- | drivers/block/cciss_cmd.h | 269 |
1 files changed, 269 insertions, 0 deletions
diff --git a/drivers/block/cciss_cmd.h b/drivers/block/cciss_cmd.h new file mode 100644 index 000000000..d9be6b4d4 --- /dev/null +++ b/drivers/block/cciss_cmd.h @@ -0,0 +1,269 @@ +#ifndef CCISS_CMD_H +#define CCISS_CMD_H + +#include <linux/cciss_defs.h> + +/* DEFINES */ +#define CISS_VERSION "1.00" + +/* general boundary definitions */ +#define MAXSGENTRIES 32 +#define CCISS_SG_CHAIN 0x80000000 +#define MAXREPLYQS 256 + +/* Unit Attentions ASC's as defined for the MSA2012sa */ +#define POWER_OR_RESET 0x29 +#define STATE_CHANGED 0x2a +#define UNIT_ATTENTION_CLEARED 0x2f +#define LUN_FAILED 0x3e +#define REPORT_LUNS_CHANGED 0x3f + +/* Unit Attentions ASCQ's as defined for the MSA2012sa */ + + /* These ASCQ's defined for ASC = POWER_OR_RESET */ +#define POWER_ON_RESET 0x00 +#define POWER_ON_REBOOT 0x01 +#define SCSI_BUS_RESET 0x02 +#define MSA_TARGET_RESET 0x03 +#define CONTROLLER_FAILOVER 0x04 +#define TRANSCEIVER_SE 0x05 +#define TRANSCEIVER_LVD 0x06 + + /* These ASCQ's defined for ASC = STATE_CHANGED */ +#define RESERVATION_PREEMPTED 0x03 +#define ASYM_ACCESS_CHANGED 0x06 +#define LUN_CAPACITY_CHANGED 0x09 + +/* config space register offsets */ +#define CFG_VENDORID 0x00 +#define CFG_DEVICEID 0x02 +#define CFG_I2OBAR 0x10 +#define CFG_MEM1BAR 0x14 + +/* i2o space register offsets */ +#define I2O_IBDB_SET 0x20 +#define I2O_IBDB_CLEAR 0x70 +#define I2O_INT_STATUS 0x30 +#define I2O_INT_MASK 0x34 +#define I2O_IBPOST_Q 0x40 +#define I2O_OBPOST_Q 0x44 +#define I2O_DMA1_CFG 0x214 + +/* Configuration Table */ +#define CFGTBL_ChangeReq 0x00000001l +#define CFGTBL_AccCmds 0x00000001l +#define DOORBELL_CTLR_RESET 0x00000004l +#define DOORBELL_CTLR_RESET2 0x00000020l + +#define CFGTBL_Trans_Simple 0x00000002l +#define CFGTBL_Trans_Performant 0x00000004l +#define CFGTBL_Trans_use_short_tags 0x20000000l + +#define CFGTBL_BusType_Ultra2 0x00000001l +#define CFGTBL_BusType_Ultra3 0x00000002l +#define CFGTBL_BusType_Fibre1G 0x00000100l +#define CFGTBL_BusType_Fibre2G 0x00000200l +typedef struct _vals32 +{ + __u32 lower; + __u32 upper; +} vals32; + +typedef union _u64bit +{ + vals32 val32; + __u64 val; +} u64bit; + +/* Type defs used in the following structs */ +#define QWORD vals32 + +/* STRUCTURES */ +#define CISS_MAX_PHYS_LUN 1024 +/* SCSI-3 Cmmands */ + +#pragma pack(1) + +#define CISS_INQUIRY 0x12 +/* Date returned */ +typedef struct _InquiryData_struct +{ + BYTE data_byte[36]; +} InquiryData_struct; + +#define CISS_REPORT_LOG 0xc2 /* Report Logical LUNs */ +#define CISS_REPORT_PHYS 0xc3 /* Report Physical LUNs */ +/* Data returned */ +typedef struct _ReportLUNdata_struct +{ + BYTE LUNListLength[4]; + DWORD reserved; + BYTE LUN[CISS_MAX_LUN][8]; +} ReportLunData_struct; + +#define CCISS_READ_CAPACITY 0x25 /* Read Capacity */ +typedef struct _ReadCapdata_struct +{ + BYTE total_size[4]; /* Total size in blocks */ + BYTE block_size[4]; /* Size of blocks in bytes */ +} ReadCapdata_struct; + +#define CCISS_READ_CAPACITY_16 0x9e /* Read Capacity 16 */ + +/* service action to differentiate a 16 byte read capacity from + other commands that use the 0x9e SCSI op code */ + +#define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10 + +typedef struct _ReadCapdata_struct_16 +{ + BYTE total_size[8]; /* Total size in blocks */ + BYTE block_size[4]; /* Size of blocks in bytes */ + BYTE prot_en:1; /* protection enable bit */ + BYTE rto_en:1; /* reference tag own enable bit */ + BYTE reserved:6; /* reserved bits */ + BYTE reserved2[18]; /* reserved bytes per spec */ +} ReadCapdata_struct_16; + +/* Define the supported read/write commands for cciss based controllers */ + +#define CCISS_READ_10 0x28 /* Read(10) */ +#define CCISS_WRITE_10 0x2a /* Write(10) */ +#define CCISS_READ_16 0x88 /* Read(16) */ +#define CCISS_WRITE_16 0x8a /* Write(16) */ + +/* Define the CDB lengths supported by cciss based controllers */ + +#define CDB_LEN10 10 +#define CDB_LEN16 16 + +/* BMIC commands */ +#define BMIC_READ 0x26 +#define BMIC_WRITE 0x27 +#define BMIC_CACHE_FLUSH 0xc2 +#define CCISS_CACHE_FLUSH 0x01 /* C2 was already being used by CCISS */ + +#define CCISS_ABORT_MSG 0x00 +#define CCISS_RESET_MSG 0x01 +#define CCISS_RESET_TYPE_CONTROLLER 0x00 +#define CCISS_RESET_TYPE_BUS 0x01 +#define CCISS_RESET_TYPE_TARGET 0x03 +#define CCISS_RESET_TYPE_LUN 0x04 +#define CCISS_NOOP_MSG 0x03 + +/* Command List Structure */ +#define CTLR_LUNID "\0\0\0\0\0\0\0\0" + +typedef struct _CommandListHeader_struct { + BYTE ReplyQueue; + BYTE SGList; + HWORD SGTotal; + QWORD Tag; + LUNAddr_struct LUN; +} CommandListHeader_struct; +typedef struct _ErrDescriptor_struct { + QWORD Addr; + DWORD Len; +} ErrDescriptor_struct; +typedef struct _SGDescriptor_struct { + QWORD Addr; + DWORD Len; + DWORD Ext; +} SGDescriptor_struct; + +/* Command types */ +#define CMD_RWREQ 0x00 +#define CMD_IOCTL_PEND 0x01 +#define CMD_SCSI 0x03 +#define CMD_MSG_DONE 0x04 +#define CMD_MSG_TIMEOUT 0x05 +#define CMD_MSG_STALE 0xff + +/* This structure needs to be divisible by COMMANDLIST_ALIGNMENT + * because low bits of the address are used to to indicate that + * whether the tag contains an index or an address. PAD_32 and + * PAD_64 can be adjusted independently as needed for 32-bit + * and 64-bits systems. + */ +#define COMMANDLIST_ALIGNMENT (32) +#define IS_64_BIT ((sizeof(long) - 4)/4) +#define IS_32_BIT (!IS_64_BIT) +#define PAD_32 (0) +#define PAD_64 (4) +#define PADSIZE (IS_32_BIT * PAD_32 + IS_64_BIT * PAD_64) +#define DIRECT_LOOKUP_BIT 0x10 +#define DIRECT_LOOKUP_SHIFT 5 + +typedef struct _CommandList_struct { + CommandListHeader_struct Header; + RequestBlock_struct Request; + ErrDescriptor_struct ErrDesc; + SGDescriptor_struct SG[MAXSGENTRIES]; + /* information associated with the command */ + __u32 busaddr; /* physical address of this record */ + ErrorInfo_struct * err_info; /* pointer to the allocated mem */ + int ctlr; + int cmd_type; + long cmdindex; + struct list_head list; + struct request * rq; + struct completion *waiting; + int retry_count; + void * scsi_cmd; + char pad[PADSIZE]; +} CommandList_struct; + +/* Configuration Table Structure */ +typedef struct _HostWrite_struct { + DWORD TransportRequest; + DWORD Reserved; + DWORD CoalIntDelay; + DWORD CoalIntCount; +} HostWrite_struct; + +typedef struct _CfgTable_struct { + BYTE Signature[4]; + DWORD SpecValence; +#define SIMPLE_MODE 0x02 +#define PERFORMANT_MODE 0x04 +#define MEMQ_MODE 0x08 + DWORD TransportSupport; + DWORD TransportActive; + HostWrite_struct HostWrite; + DWORD CmdsOutMax; + DWORD BusTypes; + DWORD TransMethodOffset; + BYTE ServerName[16]; + DWORD HeartBeat; + DWORD SCSI_Prefetch; + DWORD MaxSGElements; + DWORD MaxLogicalUnits; + DWORD MaxPhysicalDrives; + DWORD MaxPhysicalDrivesPerLogicalUnit; + DWORD MaxPerformantModeCommands; + u8 reserved[0x78 - 0x58]; + u32 misc_fw_support; /* offset 0x78 */ +#define MISC_FW_DOORBELL_RESET (0x02) +#define MISC_FW_DOORBELL_RESET2 (0x10) + u8 driver_version[32]; +} CfgTable_struct; + +struct TransTable_struct { + u32 BlockFetch0; + u32 BlockFetch1; + u32 BlockFetch2; + u32 BlockFetch3; + u32 BlockFetch4; + u32 BlockFetch5; + u32 BlockFetch6; + u32 BlockFetch7; + u32 RepQSize; + u32 RepQCount; + u32 RepQCtrAddrLow32; + u32 RepQCtrAddrHigh32; + u32 RepQAddr0Low32; + u32 RepQAddr0High32; +}; + +#pragma pack() +#endif /* CCISS_CMD_H */ |