diff options
Diffstat (limited to 'drivers/media/rc/img-ir/Kconfig')
-rw-r--r-- | drivers/media/rc/img-ir/Kconfig | 77 |
1 files changed, 77 insertions, 0 deletions
diff --git a/drivers/media/rc/img-ir/Kconfig b/drivers/media/rc/img-ir/Kconfig new file mode 100644 index 000000000..a896d3c83 --- /dev/null +++ b/drivers/media/rc/img-ir/Kconfig @@ -0,0 +1,77 @@ +config IR_IMG + tristate "ImgTec IR Decoder" + depends on RC_CORE + depends on METAG || MIPS || COMPILE_TEST + select IR_IMG_HW if !IR_IMG_RAW + help + Say Y or M here if you want to use the ImgTec infrared decoder + functionality found in SoCs such as TZ1090. + +config IR_IMG_RAW + bool "Raw decoder" + depends on IR_IMG + help + Say Y here to enable the raw mode driver which passes raw IR signal + changes to the IR raw decoders for software decoding. This is much + less reliable (due to lack of timestamps) and consumes more + processing power than using hardware decode, but can be useful for + testing, debug, and to make more protocols available. + +config IR_IMG_HW + bool "Hardware decoder" + depends on IR_IMG + help + Say Y here to enable the hardware decode driver which decodes the IR + signals in hardware. This is more reliable, consumes less processing + power since only a single interrupt is received for each scancode, + and allows an IR scancode to be used as a wake event. + +config IR_IMG_NEC + bool "NEC protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the NEC, extended NEC, and 32-bit + NEC protocols in the ImgTec infrared decoder block. + +config IR_IMG_JVC + bool "JVC protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the JVC protocol in the ImgTec + infrared decoder block. + +config IR_IMG_SONY + bool "Sony protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the Sony protocol in the ImgTec + infrared decoder block. + +config IR_IMG_SHARP + bool "Sharp protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the Sharp protocol in the ImgTec + infrared decoder block. + +config IR_IMG_SANYO + bool "Sanyo protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the Sanyo protocol (used by Sanyo, + Aiwa, Chinon remotes) in the ImgTec infrared decoder block. + +config IR_IMG_RC5 + bool "Philips RC5 protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the RC5 protocol in the ImgTec + infrared decoder block. + +config IR_IMG_RC6 + bool "Philips RC6 protocol support" + depends on IR_IMG_HW + help + Say Y here to enable support for the RC6 protocol in the ImgTec + infrared decoder block. + Note: This version only supports mode 0. |