diff options
Diffstat (limited to 'drivers/spi/spi-dw.h')
| -rw-r--r-- | drivers/spi/spi-dw.h | 212 |
1 files changed, 212 insertions, 0 deletions
diff --git a/drivers/spi/spi-dw.h b/drivers/spi/spi-dw.h new file mode 100644 index 000000000..6c91391c1 --- /dev/null +++ b/drivers/spi/spi-dw.h @@ -0,0 +1,212 @@ +#ifndef DW_SPI_HEADER_H +#define DW_SPI_HEADER_H + +#include <linux/io.h> +#include <linux/scatterlist.h> +#include <linux/gpio.h> + +/* Register offsets */ +#define DW_SPI_CTRL0 0x00 +#define DW_SPI_CTRL1 0x04 +#define DW_SPI_SSIENR 0x08 +#define DW_SPI_MWCR 0x0c +#define DW_SPI_SER 0x10 +#define DW_SPI_BAUDR 0x14 +#define DW_SPI_TXFLTR 0x18 +#define DW_SPI_RXFLTR 0x1c +#define DW_SPI_TXFLR 0x20 +#define DW_SPI_RXFLR 0x24 +#define DW_SPI_SR 0x28 +#define DW_SPI_IMR 0x2c +#define DW_SPI_ISR 0x30 +#define DW_SPI_RISR 0x34 +#define DW_SPI_TXOICR 0x38 +#define DW_SPI_RXOICR 0x3c +#define DW_SPI_RXUICR 0x40 +#define DW_SPI_MSTICR 0x44 +#define DW_SPI_ICR 0x48 +#define DW_SPI_DMACR 0x4c +#define DW_SPI_DMATDLR 0x50 +#define DW_SPI_DMARDLR 0x54 +#define DW_SPI_IDR 0x58 +#define DW_SPI_VERSION 0x5c +#define DW_SPI_DR 0x60 + +/* Bit fields in CTRLR0 */ +#define SPI_DFS_OFFSET 0 + +#define SPI_FRF_OFFSET 4 +#define SPI_FRF_SPI 0x0 +#define SPI_FRF_SSP 0x1 +#define SPI_FRF_MICROWIRE 0x2 +#define SPI_FRF_RESV 0x3 + +#define SPI_MODE_OFFSET 6 +#define SPI_SCPH_OFFSET 6 +#define SPI_SCOL_OFFSET 7 + +#define SPI_TMOD_OFFSET 8 +#define SPI_TMOD_MASK (0x3 << SPI_TMOD_OFFSET) +#define SPI_TMOD_TR 0x0 /* xmit & recv */ +#define SPI_TMOD_TO 0x1 /* xmit only */ +#define SPI_TMOD_RO 0x2 /* recv only */ +#define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */ + +#define SPI_SLVOE_OFFSET 10 +#define SPI_SRL_OFFSET 11 +#define SPI_CFS_OFFSET 12 + +/* Bit fields in SR, 7 bits */ +#define SR_MASK 0x7f /* cover 7 bits */ +#define SR_BUSY (1 << 0) +#define SR_TF_NOT_FULL (1 << 1) +#define SR_TF_EMPT (1 << 2) +#define SR_RF_NOT_EMPT (1 << 3) +#define SR_RF_FULL (1 << 4) +#define SR_TX_ERR (1 << 5) +#define SR_DCOL (1 << 6) + +/* Bit fields in ISR, IMR, RISR, 7 bits */ +#define SPI_INT_TXEI (1 << 0) +#define SPI_INT_TXOI (1 << 1) +#define SPI_INT_RXUI (1 << 2) +#define SPI_INT_RXOI (1 << 3) +#define SPI_INT_RXFI (1 << 4) +#define SPI_INT_MSTI (1 << 5) + +/* Bit fields in DMACR */ +#define SPI_DMA_RDMAE (1 << 0) +#define SPI_DMA_TDMAE (1 << 1) + +/* TX RX interrupt level threshold, max can be 256 */ +#define SPI_INT_THRESHOLD 32 + +enum dw_ssi_type { + SSI_MOTO_SPI = 0, + SSI_TI_SSP, + SSI_NS_MICROWIRE, +}; + +struct dw_spi; +struct dw_spi_dma_ops { + int (*dma_init)(struct dw_spi *dws); + void (*dma_exit)(struct dw_spi *dws); + int (*dma_setup)(struct dw_spi *dws, struct spi_transfer *xfer); + bool (*can_dma)(struct spi_master *master, struct spi_device *spi, + struct spi_transfer *xfer); + int (*dma_transfer)(struct dw_spi *dws, struct spi_transfer *xfer); + void (*dma_stop)(struct dw_spi *dws); +}; + +struct dw_spi { + struct spi_master *master; + enum dw_ssi_type type; + char name[16]; + + void __iomem *regs; + unsigned long paddr; + int irq; + u32 fifo_len; /* depth of the FIFO buffer */ + u32 max_freq; /* max bus freq supported */ + + u16 bus_num; + u16 num_cs; /* supported slave numbers */ + + /* Current message transfer state info */ + size_t len; + void *tx; + void *tx_end; + void *rx; + void *rx_end; + int dma_mapped; + u8 n_bytes; /* current is a 1/2 bytes op */ + u32 dma_width; + irqreturn_t (*transfer_handler)(struct dw_spi *dws); + + /* DMA info */ + int dma_inited; + struct dma_chan *txchan; + struct dma_chan *rxchan; + unsigned long dma_chan_busy; + dma_addr_t dma_addr; /* phy address of the Data register */ + struct dw_spi_dma_ops *dma_ops; + void *dma_tx; + void *dma_rx; + + /* Bus interface info */ + void *priv; +#ifdef CONFIG_DEBUG_FS + struct dentry *debugfs; +#endif +}; + +static inline u32 dw_readl(struct dw_spi *dws, u32 offset) +{ + return __raw_readl(dws->regs + offset); +} + +static inline void dw_writel(struct dw_spi *dws, u32 offset, u32 val) +{ + __raw_writel(val, dws->regs + offset); +} + +static inline void spi_enable_chip(struct dw_spi *dws, int enable) +{ + dw_writel(dws, DW_SPI_SSIENR, (enable ? 1 : 0)); +} + +static inline void spi_set_clk(struct dw_spi *dws, u16 div) +{ + dw_writel(dws, DW_SPI_BAUDR, div); +} + +/* Disable IRQ bits */ +static inline void spi_mask_intr(struct dw_spi *dws, u32 mask) +{ + u32 new_mask; + + new_mask = dw_readl(dws, DW_SPI_IMR) & ~mask; + dw_writel(dws, DW_SPI_IMR, new_mask); +} + +/* Enable IRQ bits */ +static inline void spi_umask_intr(struct dw_spi *dws, u32 mask) +{ + u32 new_mask; + + new_mask = dw_readl(dws, DW_SPI_IMR) | mask; + dw_writel(dws, DW_SPI_IMR, new_mask); +} + +/* + * This does disable the SPI controller, interrupts, and re-enable the + * controller back. Transmit and receive FIFO buffers are cleared when the + * device is disabled. + */ +static inline void spi_reset_chip(struct dw_spi *dws) +{ + spi_enable_chip(dws, 0); + spi_mask_intr(dws, 0xff); + spi_enable_chip(dws, 1); +} + +/* + * Each SPI slave device to work with dw_api controller should + * has such a structure claiming its working mode (poll or PIO/DMA), + * which can be save in the "controller_data" member of the + * struct spi_device. + */ +struct dw_spi_chip { + u8 poll_mode; /* 1 for controller polling mode */ + u8 type; /* SPI/SSP/MicroWire */ + void (*cs_control)(u32 command); +}; + +extern int dw_spi_add_host(struct device *dev, struct dw_spi *dws); +extern void dw_spi_remove_host(struct dw_spi *dws); +extern int dw_spi_suspend_host(struct dw_spi *dws); +extern int dw_spi_resume_host(struct dw_spi *dws); + +/* platform related setup */ +extern int dw_spi_mid_init(struct dw_spi *dws); /* Intel MID platforms */ +#endif /* DW_SPI_HEADER_H */ |