From 57f0f512b273f60d52568b8c6b77e17f5636edc0 Mon Sep 17 00:00:00 2001 From: André Fabian Silva Delgado Date: Wed, 5 Aug 2015 17:04:01 -0300 Subject: Initial import --- Documentation/i2c/busses/scx200_acb | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+) create mode 100644 Documentation/i2c/busses/scx200_acb (limited to 'Documentation/i2c/busses/scx200_acb') diff --git a/Documentation/i2c/busses/scx200_acb b/Documentation/i2c/busses/scx200_acb new file mode 100644 index 000000000..ce83c871f --- /dev/null +++ b/Documentation/i2c/busses/scx200_acb @@ -0,0 +1,32 @@ +Kernel driver scx200_acb + +Author: Christer Weinigel + +The driver supersedes the older, never merged driver named i2c-nscacb. + +Module Parameters +----------------- + +* base: up to 4 ints + Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices + + By default the driver uses two base addresses 0x820 and 0x840. + If you want only one base address, specify the second as 0 so as to + override this default. + +Description +----------- + +Enable the use of the ACCESS.bus controller on the Geode SCx200 and +SC1100 processors and the CS5535 and CS5536 Geode companion devices. + +Device-specific notes +--------------------- + +The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820. +If the scx200_acb driver is built into the kernel, add the following +parameter to your boot command line: + scx200_acb.base=0x810,0x820 +If the scx200_acb driver is built as a module, add the following line to +a configuration file in /etc/modprobe.d/ instead: + options scx200_acb base=0x810,0x820 -- cgit v1.2.3-54-g00ecf