From 57f0f512b273f60d52568b8c6b77e17f5636edc0 Mon Sep 17 00:00:00 2001 From: André Fabian Silva Delgado Date: Wed, 5 Aug 2015 17:04:01 -0300 Subject: Initial import --- drivers/net/ethernet/micrel/Kconfig | 66 +++++++++++++++++++++++++++++++++++++ 1 file changed, 66 insertions(+) create mode 100644 drivers/net/ethernet/micrel/Kconfig (limited to 'drivers/net/ethernet/micrel/Kconfig') diff --git a/drivers/net/ethernet/micrel/Kconfig b/drivers/net/ethernet/micrel/Kconfig new file mode 100644 index 000000000..d16b11ed2 --- /dev/null +++ b/drivers/net/ethernet/micrel/Kconfig @@ -0,0 +1,66 @@ +# +# Micrel device configuration +# + +config NET_VENDOR_MICREL + bool "Micrel devices" + default y + depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \ + (ARM && ARCH_KS8695) + ---help--- + If you have a network (Ethernet) card belonging to this class, say Y + and read the Ethernet-HOWTO, available from + . + + Note that the answer to this question doesn't directly affect the + kernel: saying N will just cause the configurator to skip all + the questions about Micrel devices. If you say Y, you will be asked + for your specific card in the following questions. + +if NET_VENDOR_MICREL + +config ARM_KS8695_ETHER + tristate "KS8695 Ethernet support" + depends on ARM && ARCH_KS8695 + select MII + ---help--- + If you wish to compile a kernel for the KS8695 and want to + use the internal ethernet then you should answer Y to this. + +config KS8842 + tristate "Micrel KSZ8841/42 with generic bus interface" + depends on HAS_IOMEM && DMA_ENGINE + ---help--- + This platform driver is for KSZ8841(1-port) / KS8842(2-port) + ethernet switch chip (managed, VLAN, QoS) from Micrel or + Timberdale(FPGA). + +config KS8851 + tristate "Micrel KS8851 SPI" + depends on SPI + select MII + select CRC32 + select EEPROM_93CX6 + ---help--- + SPI driver for Micrel KS8851 SPI attached network chip. + +config KS8851_MLL + tristate "Micrel KS8851 MLL" + depends on HAS_IOMEM + select MII + ---help--- + This platform driver is for Micrel KS8851 Address/data bus + multiplexed network chip. + +config KSZ884X_PCI + tristate "Micrel KSZ8841/2 PCI" + depends on PCI + select MII + select CRC32 + ---help--- + This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. + + To compile this driver as a module, choose M here. The module + will be called ksz884x. + +endif # NET_VENDOR_MICREL -- cgit v1.2.3-54-g00ecf