From 57f0f512b273f60d52568b8c6b77e17f5636edc0 Mon Sep 17 00:00:00 2001 From: André Fabian Silva Delgado Date: Wed, 5 Aug 2015 17:04:01 -0300 Subject: Initial import --- include/linux/regulator/gpio-regulator.h | 87 ++++++++++++++++++++++++++++++++ 1 file changed, 87 insertions(+) create mode 100644 include/linux/regulator/gpio-regulator.h (limited to 'include/linux/regulator/gpio-regulator.h') diff --git a/include/linux/regulator/gpio-regulator.h b/include/linux/regulator/gpio-regulator.h new file mode 100644 index 000000000..19fbd2674 --- /dev/null +++ b/include/linux/regulator/gpio-regulator.h @@ -0,0 +1,87 @@ +/* + * gpio-regulator.h + * + * Copyright 2011 Heiko Stuebner + * + * based on fixed.h + * + * Copyright 2008 Wolfson Microelectronics PLC. + * + * Author: Mark Brown + * + * Copyright (c) 2009 Nokia Corporation + * Roger Quadros + * + * This program is free software; you can redistribute it and/or + * modify it under the terms of the GNU General Public License as + * published by the Free Software Foundation; either version 2 of the + * License, or (at your option) any later version. + */ + +#ifndef __REGULATOR_GPIO_H +#define __REGULATOR_GPIO_H + +struct regulator_init_data; + +enum regulator_type; + +/** + * struct gpio_regulator_state - state description + * @value: microvolts or microamps + * @gpios: bitfield of gpio target-states for the value + * + * This structure describes a supported setting of the regulator + * and the necessary gpio-state to achieve it. + * + * The n-th bit in the bitfield describes the state of the n-th GPIO + * from the gpios-array defined in gpio_regulator_config below. + */ +struct gpio_regulator_state { + int value; + int gpios; +}; + +/** + * struct gpio_regulator_config - config structure + * @supply_name: Name of the regulator supply + * @enable_gpio: GPIO to use for enable control + * set to -EINVAL if not used + * @enable_high: Polarity of enable GPIO + * 1 = Active high, 0 = Active low + * @enabled_at_boot: Whether regulator has been enabled at + * boot or not. 1 = Yes, 0 = No + * This is used to keep the regulator at + * the default state + * @startup_delay: Start-up time in microseconds + * @gpios: Array containing the gpios needed to control + * the setting of the regulator + * @nr_gpios: Number of gpios + * @states: Array of gpio_regulator_state entries describing + * the gpio state for specific voltages + * @nr_states: Number of states available + * @regulator_type: either REGULATOR_CURRENT or REGULATOR_VOLTAGE + * @init_data: regulator_init_data + * + * This structure contains gpio-voltage regulator configuration + * information that must be passed by platform code to the + * gpio-voltage regulator driver. + */ +struct gpio_regulator_config { + const char *supply_name; + + int enable_gpio; + unsigned enable_high:1; + unsigned enabled_at_boot:1; + unsigned startup_delay; + + struct gpio *gpios; + int nr_gpios; + + struct gpio_regulator_state *states; + int nr_states; + + enum regulator_type type; + struct regulator_init_data *init_data; +}; + +#endif -- cgit v1.2.3-54-g00ecf