summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--NEWS16
1 files changed, 8 insertions, 8 deletions
diff --git a/NEWS b/NEWS
index c39939c901..8396c312bd 100644
--- a/NEWS
+++ b/NEWS
@@ -14,7 +14,7 @@ CHANGES WITH 199:
ExecStartPre= may now leave data in /tmp that ExecStart= of
the same service can still access). When a service is
stopped its temporary directories are immediately deleted
- (normal clean-up with tmpfiles still is done in addition to
+ (normal clean-up with tmpfiles is still done in addition to
this though).
* By default, systemd will now set a couple of sysctl
@@ -25,7 +25,7 @@ CHANGES WITH 199:
be reasonably safe, and good defaults for all new systems.
* The predictable network naming logic may now be turned off
- with a new kernel command line switch: net.ifnames=0
+ with a new kernel command line switch: net.ifnames=0.
* A new libsystemd-bus module has been added that implements a
pretty complete D-Bus client library. For details see:
@@ -33,10 +33,10 @@ CHANGES WITH 199:
http://lists.freedesktop.org/archives/systemd-devel/2013-March/009797.html
* journald will now explicitly flush the journal files to disk
- the latest 5min after each write. This will also mark the
- files as offline then until the next write. This should
- increase reliability. The synchronization delay can be
- configured via SyncIntervalSec= in journald.conf.
+ at the latest 5min after each write. The file will then also
+ be marked offline until the next write. This should increase
+ reliability in case of a crash. The synchronization delay
+ can be configured via SyncIntervalSec= in journald.conf.
* There's a new remote-fs-setup.target unit that can be used
to pull in specific services when at least one remote file
@@ -50,8 +50,8 @@ CHANGES WITH 199:
* libudev gained a new call udev_device_set_attribute_value()
to set sysfs attributes of a device.
- * The udev daemon now adjusts its default number of parallel
- executed worker processes based on the number of available
+ * The udev daemon now sets the default number of worker
+ processes executed in parallel based on the number of available
CPUs instead of the amount of available RAM. This is supposed
to provide a more reliable default and limit a too agressive
paralellism for setups with 1000s of devices connected.