diff options
| -rw-r--r-- | NEWS | 16 |
1 files changed, 8 insertions, 8 deletions
@@ -14,7 +14,7 @@ CHANGES WITH 199: ExecStartPre= may now leave data in /tmp that ExecStart= of the same service can still access). When a service is stopped its temporary directories are immediately deleted - (normal clean-up with tmpfiles still is done in addition to + (normal clean-up with tmpfiles is still done in addition to this though). * By default, systemd will now set a couple of sysctl @@ -25,7 +25,7 @@ CHANGES WITH 199: be reasonably safe, and good defaults for all new systems. * The predictable network naming logic may now be turned off - with a new kernel command line switch: net.ifnames=0 + with a new kernel command line switch: net.ifnames=0. * A new libsystemd-bus module has been added that implements a pretty complete D-Bus client library. For details see: @@ -33,10 +33,10 @@ CHANGES WITH 199: http://lists.freedesktop.org/archives/systemd-devel/2013-March/009797.html * journald will now explicitly flush the journal files to disk - the latest 5min after each write. This will also mark the - files as offline then until the next write. This should - increase reliability. The synchronization delay can be - configured via SyncIntervalSec= in journald.conf. + at the latest 5min after each write. The file will then also + be marked offline until the next write. This should increase + reliability in case of a crash. The synchronization delay + can be configured via SyncIntervalSec= in journald.conf. * There's a new remote-fs-setup.target unit that can be used to pull in specific services when at least one remote file @@ -50,8 +50,8 @@ CHANGES WITH 199: * libudev gained a new call udev_device_set_attribute_value() to set sysfs attributes of a device. - * The udev daemon now adjusts its default number of parallel - executed worker processes based on the number of available + * The udev daemon now sets the default number of worker + processes executed in parallel based on the number of available CPUs instead of the amount of available RAM. This is supposed to provide a more reliable default and limit a too agressive paralellism for setups with 1000s of devices connected. |