diff options
Diffstat (limited to 'NEWS')
| -rw-r--r-- | NEWS | 19 |
1 files changed, 10 insertions, 9 deletions
@@ -38,7 +38,7 @@ CHANGES WITH 230 in spe: and any service that should survive the end of any individual login session can be started at a user service or scope using systemd-run. systemd-run(1) man page has been extended with an example which shows - how to run screen in a scope unit underneath user@.service. The same + how to run screen in a scope unit underneath user@.service. The same command works for tmux. After the user logs out of all sessions, user@.service will be @@ -62,8 +62,8 @@ CHANGES WITH 230 in spe: * LLDP support has been extended, and both passive (receive-only) and active (sender) modes are supported. Passive mode ("routers-only") is - enabled by default in systemd-networkd. Active LLDP mode is enabled - by default for containers on the internal network. The "networkctl + enabled by default in systemd-networkd. Active LLDP mode is enabled + by default for containers on the internal network. The "networkctl lldp" command may be used to list information gathered. "networkctl status" will also show basic LLDP information on connected peers now. @@ -101,7 +101,8 @@ CHANGES WITH 230 in spe: * "systemctl show" gained a new --value switch, which allows print a only the contents of a specific unit property, without also printing - the property's name. + the property's name. Similar support was added to "show*" verbs + of loginctl and machinectl that output "key=value" lists. * A new command "systemctl revert" has been added that may be used to revert to the vendor version of a unit file, in case local changes @@ -111,7 +112,7 @@ CHANGES WITH 230 in spe: just hidden container images. * systemd-bus-proxyd has been removed, as kdbus is unlikely to still be - merged into the kernerl in its current form. + merged into the kernel in its current form. * systemd-networkd gained support for configuring proxy ARP support for each interface, via the ProxyArp= setting in .network files. It also @@ -142,11 +143,11 @@ CHANGES WITH 230 in spe: changed to use this functionality by default. * The default start timeout may now be configured on the kernel command - line via systemd.default_timeout_start_sec=. It was configurable - previously via the DefaultTimeoutStartSec= option in - /etc/systemd/system.conf already. + line via systemd.default_timeout_start_sec=. It was already + configurable via the DefaultTimeoutStartSec= option in + /etc/systemd/system.conf. - * Socket units gaineda new TriggerLimitIntervalSec= and + * Socket units gained a new TriggerLimitIntervalSec= and TriggerLimitBurst= setting to configure a limit on the activation rate of the socket unit. |