summaryrefslogtreecommitdiff
path: root/man/systemd.netdev.xml
AgeCommit message (Collapse)Author
2015-01-13doc: add cross-references between systemd.{link, netdev, network}Jan Engelhardt
2014-12-04networkd: support vxlan parametersSusant Sahani
V3: fix copy paste error V4: Make manual and config more readable Add vxlan paramertes to config.
2014-08-18networkd: warn when ignoring unsupported tuntap optionsTom Gundersen
The interface for creating tuntap devices should be ported to rtnl so it would support the same settings as other kinds. In the meantime, the best one can do is to drop in a .link file to set the desired options.
2014-07-21networkd: add support for bond optionsSusant Sahani
The following bond options are supported by this patch. MIIMonitorSec: Specifies the frequency in milli-seconds that MII link monitoring will occur. UpDelaySec: Specifies the delay time in milli-seconds to enable a link after a link up status has been detected. DownDelaySec: Specifies the delay time in milli-seconds to disable a link after a link failure has been detected. changes: 1. Added gconf variables. 2. man page conf: [NetDev] Name=bond1 Kind=bond [Bond] Mode=802.3ad TransmitHashPolicy=layer2+3 LacpduTransmitRate=fast MIIMonitorSec=1s UpDelaySec=2s DownDelaySec=8s cat /proc/net/bonding/bond1 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2+3 (2) MII Status: up MII Polling Interval (ms): 1000 Up Delay (ms): 2000 Down Delay (ms): 8000 802.3ad info LACP rate: fast Min links: 0 Aggregator selection policy (ad_select): stable bond bond1 has no active aggregator [tomegun: rephrased manpage, dropped bond_ prefix from variables]
2014-07-21networkd: bond add support for lacp rateSusant Sahani
LacpduTransmitRate option specifies the rate in which link partner to transmit LACPDU packets in 802.3ad mode. Possible values slow : Request partner to transmit LACPDUs every 30 seconds fast : Request partner to transmit LACPDUs every 1 second The default is slow. chages: 1. Added enum bond_lacp_rate_table 2. gperf LacpduTransmitRate Test: conf file: [NetDev] Name=bond1 Kind=bond [Bond] Mode=802.3ad LacpduTransmitRate=fast test: cat /proc/net/bonding/bond1 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2+3 (2) MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 802.3ad info LACP rate: fast Min links: 0 Aggregator selection policy (ad_select): stable bond bond1 has no active aggregator [tomegun: renamed from LacpduTransmitRate to LACPTransmitRate, manpage fixes and dropped bond_ prefix from variables]
2014-07-21networkd: add support for bond transmit hash policySusant Sahani
This patch adds support the transmit hash policy to use for slave selection in balance-xor, 802.3ad, and tlb modes layer2, layer3+4, layer2+3, encap3+4, encap3+4 Added: 1. BondXmitHashPolicy 2. conf param TransmitHashPolicy Test conf: [NetDev] Name=bond1 Kind=bond [Bond] Mode=802.3ad TransmitHashPolicy=layer2+3 test output: cat /proc/net/bonding/bond1 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2+3 (2) MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 802.3ad info LACP rate: slow Min links: 0 Aggregator selection policy (ad_select): stable bond bond1 has no active aggregator [tomegun: dropped bond_ prefix from new Bond variable, drop repeated man-page section]
2014-07-14man: systemd.netdev - make it clear that we do not touch preexisting netdevsTom Gundersen
We will happily use bridges/bonds as master devices, but we will not change their settings if they were created by someone else.
2014-07-07networkd: add support for modeSusant Sahani
This patch adds supports networkd to configure bond mode during creation via persistent conf. Mode can be configured with conf param 'Mode'. A new section Bond is added to the conf to support bond mode. These modes can be configured now. balance-rr active-backup balance-xor broadcast 802.3ad balance-tlb balance-alb Example conf file: test-bond.conf [NetDev] Name=bond1 Kind=bond [Bond] Mode=balance-xor Test case: 1. start networkd service: 12: bond1: <BROADCAST,MULTICAST,MASTER,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN mode DEFAULT group default link/ether 22:89:6c:47:23:d2 brd ff:ff:ff:ff:ff:ff 2. find bond mode: cat /proc/net/bonding/bond1 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: load balancing (xor) Transmit Hash Policy: layer2 (0) MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 Changes: 1. Added file networkd-bond.c 2. Bond mode enum BondMode 3. conf section [Bond] [tomegun: whitespace]
2014-07-04man: netdev - mention tun and tapTom Gundersen
Reported by Moviuro <moviuro@gmail.com>
2014-07-03networkd: tuntap - default to no packet informationTom Gundersen
Susant says: > ip tuntap turns this off by default. Let's follow ip(8) here as that should be the least surprising.
2014-07-03networkd: tuntap - manpage fixesTom Gundersen
2014-07-03networkd: Introduce tun/tap deviceSusant Sahani
This patch introduces TUN/TAP device creation support to networkd. Example conf to create a tap device: file: tap.netdev ------------------ [NetDev] Name=tap-test Kind=tap [Tap] OneQueue=true MultiQueue=true PacketInfo=true User=sus Group=sus ------------------ Test: 1. output of ip link tap-test: tap pi one_queue UNKNOWN_FLAGS:900 user 1000 group 1000 id: uid=1000(sus) gid=10(wheel) groups=10(wheel),1000(sus) context=unconfined_u:unconfined_r:unconfined_t:s0-s0:c0.c1023 Modifications: Added: 1. file networkd-tuntap.c 3. netdev kind NETDEV_KIND_TUN and NETDEV_KIND_TAP 2. Tun and Tap Sections and config params to parse conf and gperf conf parameters [tomegun: tweak the 'kind' checking for received ifindex]
2014-07-01networkd: netdev - add dummy supportTom Gundersen
2014-07-01man: bring systemd.netdev(5) up-to-dateTom Gundersen
Based on a diff by the mysterious 'poma'.
2014-06-27man: split systemd.network(5) and related into various sections for better ↵Lennart Poettering
readability
2014-03-17man: networkd - additional examples related to bridgingpoma
2014-02-25networkd: add basic support for MACVLANsTom Gundersen
2014-02-25man: split out systemd.net{work,dev}(5) from systemd-networkd(8)Tom Gundersen