| Age | Commit message (Collapse) | Author |
|---|
|
This patch converts PID 1 to libsystemd-bus and thus drops the
dependency on libdbus. The only remaining code using libdbus is a test
case that validates our bus marshalling against libdbus' marshalling,
and this dependency can be turned off.
This patch also adds a couple of things to libsystem-bus, that are
necessary to make the port work:
- Synthesizing of "Disconnected" messages when bus connections are
severed.
- Support for attaching multiple vtables for the same interface on the
same path.
This patch also fixes the SetDefaultTarget() and GetDefaultTarget() bus
calls which used an inappropriate signature.
As a side effect we will now generate PropertiesChanged messages which
carry property contents, rather than just invalidation information.
|
|
https://bugs.freedesktop.org/show_bug.cgi?id=71132
Patch adds DefaultTimeoutStartSec, DefaultTimeoutStopSec, DefaultRestartSec
configuration options to manager configuration file.
|
|
controllers
Previously we did operations like attach, trim or migrate only on the
controllers that were enabled for a specific unit. With this changes we
will now do them for all supproted controllers, and fall back to all
possible prefix paths if the specified paths do not exist.
This fixes issues if a controller is being disabled for a unit where it
was previously enabled, and makes sure that all processes stay as "far
down" the tree as groups exist.
|
|
We don't allow reusing of scopes.
|
|
When a scope unit is created due to deserialization rather than client
request don't enforce that the PIDs set must be non-empty, since the
cgroup is already populated.
|
|
|
|
|
|
"Scope" units are very much like service units, however with the
difference that they are created from pre-existing processes, rather
than processes that systemd itself forks off. This means they are
generated programmatically via the bus API as transient units rather
than from static configuration read from disk. Also, they do not provide
execution-time parameters, as at the time systemd adds the processes to
the scope unit they already exist and the parameters cannot be applied
anymore.
The primary benefit of this new unit type is to create arbitrary cgroups
for worker-processes forked off an existing service.
This commit also adds a a new mode to "systemd-run" to run the specified
processes in a scope rather then a transient service.
|
