| Age | Commit message (Collapse) | Author |
|---|
|
https://bugzilla.redhat.com/show_bug.cgi?id=787314
|
|
As passive units only are useful for ordering things within the initial
transaction there is no point in ever activating them manually, hence
refuse it.
|
|
basic.target
There isn't really any need to require any targets but sysinit.target
from basic.target, so downgrade sockets.target, paths.target,
timers.target.
|
|
Units such as nss-lookup.target, nss-user-lookup.target,
remote-fs-pre.target, local-fs-pre.target, time-sync.target,
rpcbind.target are to be pulled in by the implementing services, and
that's there only purpose. They should not have any 'active component'
otherwise, so let's drop all further deps from these units.
|
|
mounts
This introduces remote-fs-setup.target independently of
remote-fs-pre.target. The former is only for pulling things in, the
latter only for ordering.
The new semantics:
remote-fs-setup.target: is pulled in automatically by all remote mounts.
Shall be used to pull in other units that want to run when at least one
remote mount is set up. Is not ordered against the actual mount units,
in order to allow activation of its dependencies even 'a posteriori',
i.e. when a mount is established outside of systemd and is only picked
up by it.
remote-fs-pre.target: needs to be pulled in automatically by the
implementing service, is otherwise not part of the initial transaction.
This is ordered before all remote mount units.
A service that wants to be pulled in and run before all remote mounts
should hence have:
a) WantedBy=remote-fs-setup.target -- so that it is pulled in
b) Wants=remote-fs-pre.target + Before=remote-fs-pre.target -- so that
it is ordered before the mount point, normally.
|
|
This reverts commit 6bde0b3220e95a08cefb70846f73b2cf24b7734a.
We should not pull in remote-fs-pre.target unconditionally. It's
supposed to be pulled in by the implementors of it, rather then its
users.
|
|
|
|
Not that it would matter much, but let's make things a bit more
systematic: early boot services shall order themselves before
sysinit.target, and nothing else.
|
|
into for boot
|
|
|
|
|
|
static nodes (like /dev/loop-control) are created when systemd-udevd
is started and needed to mount loopback devices. Therefore,
local-fs-pre.target should be only started after systemd-udevd is
started.
|
|
While most folks will be using the derivative from user-session-units,
I'm updating this one to reflect some of the fixes and things to note
about user sessions:
- cgroup should be set with "%u" - username instead of %I
- set dbus path with %U explicitly too
- hint to folks that wish to use MEM_CG features in user sessions
- allow unit to be enabled for instances with systemctl enable
|
|
This reverts commit faeffa73a81ab5b59acfadeb571431fb0e42af70.
There isn't really much point in dropping the Conflicts= since shutting
down this service is basically free as it doesn't have anything running.
Also, the patch was incomplete, because shutdown.target was still listed
in Before=.
|
|
|
|
No need to try to stop systemd-sysctl on shutdown as
this service doesn't have ExecStop= anyways.
|
|
First, rename root-fs.target to initrd-root-fs.target to clarify its usage.
Mount units with "x-initrd-rootfs.mount" are now ordered before
initrd-root-fs.target. As we sometimes construct /sysroot mounts in
/etc/fstab in the initrd, we want these to be mounted before the
initrd-root-fs.target is active.
initrd.target can be the default target in the initrd.
(normal startup)
:
:
v
basic.target
|
______________________/|
/ |
| sysroot.mount
| |
| v
| initrd-root-fs.target
| |
| v
| initrd-parse-etc.service
(custom initrd services) |
| v
| (sysroot-usr.mount and
| various mounts marked
| with fstab option
| x-initrd.mount)
| |
| v
| initrd-fs.target
| |
\______________________ |
\|
v
initrd.target
|
v
initrd-cleanup.service
isolates to
initrd-switch-root.target
|
v
______________________/|
/ |
| initrd-udevadm-cleanup-db.service
| |
(custom initrd services) |
| |
\______________________ |
\|
v
initrd-switch-root.target
|
v
initrd-switch-root.service
|
v
switch-root
|
|
Instead of using local-fs*.target in the initrd, use root-fs.target for
sysroot.mount and initrd-fs.target for /sysroot/usr and friends.
Using local-fs.target would mean to carry over the activated
local-fs.target to the isolated initrd-switch-root.target and thus in
the real root. Having local-fs.target already active after
deserialization causes ordering problems with the real root services and
targets.
We better isolate to targets for initrd-switch-root.target, which are
only available in the initrd.
|
|
This pulls in remote-fs-pre.target if remote-fs.target is needed.
Previously remote-fs-pre.target was not active, if no remote fs was
mounted from /etc/fstab. So, every manual remote fs mount was ordered
against the inactive remote-fs-pre.target and umount.target.
Because remote-fs-pre.target was not active, the remote fs was umounted
at umount.target time, which was too late (network already down).
Now remote-fs-pre.target is active, even if no remote fs is mounted.
On shutdown it is deactivated in the correct order and all manual remote
fs mounts also.
|
|
|
|
for the changes in 7b40ce553f0ec9487077e53f5bdc46580025901c
|
|
The udevadm utility is needed during early boot, so move it to
rootbindir to support split-/usr configurations.
|
|
Instead use @bindir@ for udevadm and @rootbindir@ for systemctl.
|
|
systemd-vconsole-setup.service
|
|
|
|
This reverts commit 39b83cdab37623a546344622db9bbbc784c15df5.
|
|
This reverts commit 7d89ce303fb59743a4392eeb3110c00f100172ca.
|
|
|
|
|
|
|
|
This will:
* mount all configured filesystems (typically the rootfs on /sysroot)
* reload the configuration to pick up anything from the mounted fs (typically
/sysroot/etc/fstab)
* mount any newly configured filesystems (typically /usr on /sysroot/usr, if
applicable)
* shut-down and clean-up any daemons running in the initramfs (typically udevd)
* switch-root to /sysroot and start the real init
For an example of what files should be included in an initramfs based on this
see
<https://mailman.archlinux.org/pipermail/arch-projects/2013-February/003628.html>.
Cc: Harald Hoyer <harald.hoyer@gmail.com>
Cc: Dave Reisner <d@falconindy.com>
|
|
Sometimes it is useful to look at them, and they don't take
up any significant amount of space. Keeping them also avoids
the message about files being removed at the end of make
run.
|
|
We no longer allow early-boot init scripts, however in late boot the
syslog socket and local mounts are established anyway, so let's simplify
our dep graph a bit.
If $syslog doesn't resolve to syslog.target anymore there's no reason to
keep syslog.target around anymore. Let's remove it.
Note that many 3rd party service unit files order themselves after
syslog.target. These will be dangling dependencies now, which should be
unproblematic, however.
|
|
Systemd should not introduce any new facilities. Distributions which still
need to support their non-standard/legacy facilities should add them as
patches to their packaging.
The following facilities are no longer recognized:
$x-display-manager
$mail-transfer-agent
$mail-transport-agent
$mail-transfer-agent
$smtp
$null
This target is no longer available:
mail-transfer-agent.target
|
|
|
|
|
|
|
|
sushell makes much less sense than sulogin. If distros want to stick to sushell
they should patch this downstream.
|
|
Since rc-local is now enabled via the SysV compatibility we should only refer
to it based on that too.
|
|
This also drops automatic selection of the rc local scripts
based on the local distro. Distributions now should specify the paths
of the rc-local and halt-local scripts on the configure command line.
|
|
virtualization works
|
|
Frugalware are shipping their own .service file now, so stop shipping
it here.
This effectively reverts 196e3fa74a88a04b0ecec7d3af648287dd088f8a
|
|
|
|
|
|
specific
This was premarily intended to support the LSB facility $httpd which is
only known by Fedora, and a bad idea since it lacks any real-life
usecase.
Similar, drop support for some other old Fedora-specific facilities.
Also, document the rules for introduction of new facilities, to clarify
the situation for the future.
|
|
Environment=TERM=... has no effect on agetty who sets it by itself. To
really set TERM to a specified value, it has to be given on the command
line.
https://bugzilla.redhat.com/show_bug.cgi?id=870622
|
|
This makes the behaviour wrt. to rc[-.]local consistent between
various distributions supporting it.
|
|
Do not suggest to the user that commands can be issued before
logging in.
sulogin prints it own message, which mentions ^D, so there's no need
to repeat it here.
|
|
|
|
Since tmp.mount is a tmpfs this is not necesary, and should speed up boot marginally.
|
