systemd Documentation Zbigniew Jędrzejewski-Szmek zbyszek@in.waw.pl networkctl 1 networkctl Query the status of network links networkctl OPTIONS COMMAND LINK networkctl may be used to introspect the state of the network links as seen by systemd-networkd. Please refer to systemd-networkd.service8 for an introduction to the basic concepts, functionality, and configuration syntax. The following options are understood: -a --all Show all links with status. The following commands are understood: list Show a list of existing links and their status. Produces output similar to IDX LINK TYPE OPERATIONAL SETUP 1 lo loopback carrier unmanaged 2 eth0 ether routable configured 3 virbr0 ether no-carrier unmanaged 4 virbr0-nic ether off unmanaged 4 links listed. status LINK... Show information about the specified links: type, state, kernel module driver, hardware and IP address, configured DNS servers, etc. When no links are specified, routable links are shown. See also option --all. Produces output similar to ● State: routable Address: 10.193.76.5 on eth0 192.168.122.1 on virbr0 169.254.190.105 on eth0 fe80::5054:aa:bbbb:cccc on eth0 Gateway: 10.193.11.1 (CISCO SYSTEMS, INC.) on eth0 DNS: 8.8.8.8 8.8.4.4 lldp Show LLDP (Link Layer Discovery Protocol) status. On success, 0 is returned, a non-zero failure code otherwise. systemd-networkd.service8, systemd.network5, systemd.netdev5