systemd.swapsystemdDeveloperLennartPoetteringlennart@poettering.netsystemd.swap5systemd.swapsystemd swap configuration filessystemd.swapDescriptionA unit configuration file whose name ends in
.swap encodes information about a
swap device or file for memory paging controlled and
supervised by systemd.This man page lists the configuration options
specific to this unit type. See
systemd.unit5
for the common options of all unit configuration
files. The common configuration items are configured
in the generic [Unit] and [Install] sections. The swap
specific configuration options are configured in the
[Swap] section.Swap units must be named after the devices
(resp. files) they control. Example: the swap device
/dev/sda5 must be configured in a
unit file dev-sda5.swap. For
details about the escaping logic used to convert a
file system path to a unit name see
systemd.unit5.All swap units automatically get the appropriate
dependencies on the devices (resp. on the mount points
of the files) they are actived from.Swap units with
DefaultDependencies= enabled
implicitly acquire a conflicting dependency to
umount.target so that they are
deactivated at shutdown.<filename>fstab</filename>Swap units may either be configured via unit
files, or via /etc/fstab (see
fstab5
for details).If a swap device or file is configured in both
/etc/fstab and a unit file the
configuration in the latter takes precedence.Unless the option is set
for them all swap units configured in
/etc/fstab are also added as
requirements to swap.target, so
that they are waited for and activated during
boot.OptionsSwap files must include a [Swap] section, which
carries information about the swap device it
supervises. A number of options that may be used in
this section are shared with other unit types. These
options are documented in
systemd.exec5. The
options specific to the [Swap] section of swap units
are the following:What=Takes an absolute path
of a device node or file to use for
paging. See
swapon8
for details. If this refers to a
device node, a dependency on the
respective device unit is
automatically created. (See
systemd.device5
for more information.) If this refers
to a file, a dependency on the
respective mount unit is automatically
created. (See
systemd.mount5
for more information.) This option is
mandatory.Priority=Swap priority to use
when activating the swap device or
file. This takes an integer. This
setting is optional.TimeoutSec=Configures the time to
wait for the swapon command to
finish. If a command does not exit
within the configured time the swap
will be considered failed and be shut
down again. All commands still running
will be terminated forcibly via
SIGTERM, and after another delay of
this time with SIGKILL. (See
below.)
Takes a unit-less value in seconds, or
a time span value such as "5min
20s". Pass 0 to disable the timeout
logic. Defaults to
3min.KillMode=Specifies how
processes of this swap shall be
killed. One of
,
,
.This option is mostly equivalent
to the
option of service files. See
systemd.service5
for details.KillSignal=Specifies which signal
to use when killing a process of this
swap. Defaults to SIGTERM.
SendSIGKILL=Specifies whether to
send SIGKILL to remaining processes
after a timeout, if the normal
shutdown procedure left processes of
the swap around. Takes a boolean
value. Defaults to "yes".
See Alsosystemd1,
systemctl8,
systemd.unit5,
systemd.exec5,
systemd.device5,
systemd.mount5,
swapon8