1 files changed, 35 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
new file mode 100644
index 000000000..b6a7e7397
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
@@ -0,0 +1,35 @@
+Mediatek DPI Device
+===================
+
+The Mediatek DPI function block is a sink of the display subsystem and
+provides 8-bit RGB/YUV444 or 8/10/10-bit YUV422 pixel data on a parallel
+output bus.
+
+Required properties:
+- compatible: "mediatek,<chip>-dpi"
+- reg: Physical base address and length of the controller's registers
+- interrupts: The interrupt signal from the function block.
+- clocks: device clocks
+  See Documentation/devicetree/bindings/clock/clock-bindings.txt for details.
+- clock-names: must contain "pixel", "engine", and "pll"
+- port: Output port node with endpoint definitions as described in
+  Documentation/devicetree/bindings/graph.txt. This port should be connected
+  to the input port of an attached HDMI or LVDS encoder chip.
+
+Example:
+
+dpi0: dpi@1401d000 {
+	compatible = "mediatek,mt8173-dpi";
+	reg = <0 0x1401d000 0 0x1000>;
+	interrupts = <GIC_SPI 194 IRQ_TYPE_LEVEL_LOW>;
+	clocks = <&mmsys CLK_MM_DPI_PIXEL>,
+		 <&mmsys CLK_MM_DPI_ENGINE>,
+		 <&apmixedsys CLK_APMIXED_TVDPLL>;
+	clock-names = "pixel", "engine", "pll";
+
+	port {
+		dpi0_out: endpoint {
+			remote-endpoint = <&hdmi0_in>;
+		};
+	};
+};